|
TROUBLESHOOTING Not
able to get the Aztech CD-ROM to work with the IBM Dala-3450 Hard drive:
This is caused because the pulse width for DASP signal is not asserted long enough by
the CD-ROM drive to comply with that of IBM hard disk, which
requires a minimum of 400ms timing. This resulted to the improper detection of Aztech IDE
CD-ROM Drive. This issue can be resolved by updating the CD-ROM's Firmware, which can be
found on the Aztech's Driver Page.
MS-DOS CD-ROM Driver installation procedure:
See our CD-ROM Driver information page if you are having
difficulties loading your CD-ROM driver in your autoexec.bat / Config.sys.
General CD-ROM troubleshooting:
See our CD-ROM troubleshooting page which lists complete
information on computer CD-ROM drives.
|
